Tuesday, July 25, 2017

Momentarily Displacement Force Thrust

(Amendments to this article were made, click here to view the latest version) 
The momentarily displacement force thrust (to be referred to as MDF thrust) is a closed system that doesn't use any rocket propulsion nor propels any matter, molecules or ions..etc to produce thrust. The system facilitated the theory/phenomenon of the momentarily displacement force resulting from releasing less dense matter (floats, air bubbles...etc) from under the surface of a higher density fluid.

A. Momentarily Displacement Force

Any matter ingested in fluid container will cause the fluid level to rise, increasing the pressure on the container's floor, when that pressure is multiplied to the floor area, that would be the forces towards the acceleration (gravity) .

A simple example for that is a balloon tethered to the floor of a water tank, the downward force will increase with an amount equal to the balloon size (displacement), however there's another upward force caused by the balloon pulling up on the tank's floor with a force equal to the balloon displacement, hence the tank weight doesn't change until the thread is cut (balloon released), the upward force is removed and only the extra downward force remain temporarily for limited time governed by a group of factors, primarily the balloon reaching the surface or reaching its terminal velocity.

A.1. Momentarily Displacement Force Experiment

The experiment illustrated in Fig(A) is to prove the momentarily displacement force
                                                  Fig (A)

a water tank filled with 10 L of water
1/10 of its floor is replaced by a piston that moves freely in a cylinder which is a part of the tank
scale (1) measures the tank's weight
scale (2) measures the piston downward force.

Phase 1
The initial readings if all materials weight was ignored except for the water will be:
scale (1) …. 9 kg
scale (2) …..1 kg
a total of 10 kg

Phase 2
A balloon with 1L volume is forced into the tank, the readings will be as follow:
scale (1) ….. 9.9 kg
scale (2) ….. 1.1 kg
a total of 11 kg due to the external force pushing the balloon into the water

Phase 3
The balloon is tethered to the piston, the readings will be as follow:
scale (1) ….. 9.9 kg
scale (2) ….. 1.1 – 1.0 = 0.1
1.1 kg downward force same as phase 1 minus 1kg upward force due to the balloon tethering
total is 10 kg which is expected since there's no external force and the water volume is 10L

Phase 4
cutting the thread , instantly removing the red bold text from the previous phase
scale (1) ….. 9.9
scale (2) ….. 1.1
total of 11 kg

Final phase
the balloon reach the surface or its terminal velocity and the effect is gone, back to phase 1



B. altering the MDF expriment

The experiment is not limited to a tank and scales with setting in Fig (A) , any tank shape and single scale will give the same result, the purpose of the above settings is to analyse the forces and prove the theory without laboratory equipments.

Another variation could be pumping air at the tank floor with a sufficient amount of air flow through many pipes or having the whole floor with suitably distributed holes .
                                                      Fig (B)



C. Applying MDF for thrust

It appears for a moment that the application for the MDF is increasing a container's weight , since the MDF works along with the gravity (acceleration) towards earth. But acceleration can be produced in the desired direction as needed through centrifugal force.

If water to be rotated in circular tube (doughnut shape) where one side is equipped with MDF producers , then there will be more force towards that direction even though the centrifugal acceleration is equal on both sides
                                                       Fig (C)